Valve out of adjustment will not cause wet plugs. Number one cause of wet plugs is too rich of a mixture, or bad valve stem seals. My first...
Try checking in with the guys over aat the “livetodai” forum. they are wealth of knowledge for everything Daihatsu.
re used to be a guy on the forum who put a flat six engine from a BMW motorcycle under a Daihatsu Atrai two wheel drive. Said it would go like...
“Safe for Yellow Metal”. the synchros rings are bronze, and some lubricants will dissolve the copper out of the bronze. Which leaves the rings...
Run it for a bit and check the plugs. If they are sooty, you are too rich. Not sure who makes youre carb. Jets from motor cycles sometimes work.
I think the vacuum valve is supposed to release the vacuum when it closes the feed.
I would get a dump, or scissors lift/dump again in a minute, particularly fr a site truck. I think working on the engine is lots easier than...
Ok, the “Venturi Adjustment”, is the idle mixture adjustment. You may have to pop the Plastic off of it to get a full range of adjustment. I...
You will need to upgrade the springs. The blackline is a heavy plow. I ended up with a set of variable rate springs 150 to 450-lbs/inch, from...
That is right. I think, not sure on the idle and the load kick up screw. Post a side view and I will know for sure.
Wheels and tires, I have a two inch lift, to get more clearance. 14X6 ATV Wheels, with 165/75R14s. The tires a Nokia winter with open lugs but...
Transmission, (Transfer case is integrated), 3.1-liters of Gear Lube, not sure what weight. I used a synthetic 50w-90. The spec is for GL3,...
Oil 10W-30 SE, 3.1-liter, Filter FRAM PH4967, NAPA Gold 1394, NAPA 41394, or Wix 51394. Any parts house should be able to cross reference from...
Japanese gasoline has ethanol. Less than in the US, but around 2%. The fuel line is probably ethanol resistant.
First go into your profile, and put some info on your truck in the signature. It makes it lots easier to lend a hand when you need a hand....
Separate names with a comma.