1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Alternator failed replacement is slightly different

Discussion in 'Mini Lounge' started by AKminitrack, Dec 2, 2020.

  1. AKminitrack

    AKminitrack New Member

    My Suzuki alternator 31400-65h30 failed and I cannot rebuild it. I ordered one and they sent me a 31400-76h11. It’s almost exactly the same except for the connector plug. OEM was 3pin, new in 4pin. It will Mount right up and go round, but I’m not sure if I’ll damage the system if I run it with only 3 wires connected through a spliced 4pin connector. I would be able to accommodate the three wires on my harness , but would not hook up the white/green altctrl wire. Is this doable? Does anyone have experience with this? I had a hell of a time finding the oem alternator in the states.

    thanks for any help you can give.

    Jason
     
  2. AKminitrack

    AKminitrack New Member

    Here’s photos

    2010 carry k6a da63t
     

    Attached Files:

  3. AKminitrack

    AKminitrack New Member

    One more
     

    Attached Files:

  4. Roadster

    Roadster Member

    Jigs -N-Fixtures did a good reply about 4 wire alternators in the Daihatsu section (or New Posts!) A search there might help you... the fourth wire is for the dash idiot light according to him.
     
    Limestone likes this.
  5. AKminitrack

    AKminitrack New Member

    Thank you I’ll check it out
     

Share This Page