Yeah that's how rich it's running. Mixture screw for this carb must be way to far out or rich. It's choking itself out. It was rich before I...
Seems like the best tool for the air mixture screw is a penny,dime, or a quarter. Just not much room in there for a tool. Couldn't even get my...
I connected the airbox and she is running horribly rich. Sputtering like an old airplane puffing blue smoke and struggling to run it's so rich....
I totally agree on the mixture adjustments. That will be the for sure one. I'll connect the airbox and look at it tonight
I disagree on that one but I could be wrong. If all you change is the diaphragms, gaskets and clean out the passages/jets etc there should be no...
Yes all fuel lines were replaced 4years ago. Also if that was the case the strainer just inside of the inlet tube on the carburetor would have...
So I peeled this carb apart. What a mess of dirt inside. Looked like someone tossed a couple pinches of black dirt in the bowl and ran the carb...
To isolate that I took the inlet fuel line off and turned the key. Plenty of fuel spraying everywhere. However. When stabbing the accelerator...
I just built a front bumper out of 2 inch tubing(not pipe). I welded the mounting studs directly to the frame by poking straight through the...
Also for the air filters. I see the center filter off the duct. Explanatory. What about upper glove box area? Is that another.
Did you find a way to allow the vent to blow warm air when you were in there? That has been a deal for me as you stated, for the past 10 years....
Separate names with a comma.
