Yes, there is a stud sticking out that takes an Allen wrench to turn it. Lower left hand side. Diagonal to the bolt you found
Well i finally got the carb off. Not looking good. Looks like a mix of molasses and tar. Got it soaking in cleaner for now.
trying to get the hijet running again after it set up for a couple of years. I have spark, fuel pump works, and will run on starter fluid. Fuel...
my truck will now go just as far in 2wd drive with a welded diff as it did before in 4wd with an open (nonwelded) diff. In 2 wheel drive with an...
one thing to check for is the front diff mount. the bushings will wear down and get a bad clunking noise to them. I replaced the struts on my...
finally got time to finish my bumper [IMG]
I finally got my drop steering arm built and everything put back together. I had a small delay, the short side axle came out of the diff when I...
greg, I had found your pic of the drop steering arm. I like the design of it but think it may be a little out of my capability. I was wondering...
was going to build a drop steering ar for my hijet. was wanting some opinions on my design. I was going to use a piece of 1/4 inch angle for the...
try a little rock bouncing http://www.youtube.com/watch?v=4A98SJg-iuc&list=UUQMYWynQkK-Q-sd0u2_rF0A&feature=plcp
front end clunking is about the best description to the sound my hijet was making in 4wd. I could not figure out where it was coming from. I...
Separate names with a comma.