1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Recent Content by Rick Melloh

  1. Rick Melloh
    Post

    Sambar TT2 ball joint sourcing

    I promised to confirm if the ball joints I ordered were a good fit for the TT2. Yes they are. I ordered a pair of Duralast FA1296 ball joints....
    Post by: Rick Melloh, Nov 28, 2021 in forum: Subaru Sambar
  2. Rick Melloh
    Post

    Sambar TT2 ball joint sourcing

    Well, that would make perfect sense, in a crazy world. So close, but no cigar. We'll muddle on, never give up.
    Post by: Rick Melloh, Nov 10, 2021 in forum: Subaru Sambar
  3. Rick Melloh
    Post

    Sambar TT2 ball joint sourcing

    Looks like those half moon, front backplates might be installable without removing the hub, just the caliper and brake disc. Is that a correct...
    Post by: Rick Melloh, Nov 10, 2021 in forum: Subaru Sambar
  4. Rick Melloh
    Post

    Sambar TT2 ball joint sourcing

    Thanks for the info, rkrenicki. My chassis number is TT2FHBT 172620. Had the flex pipe for the catalytic converter replaced this morning, sort of...
    Post by: Rick Melloh, Nov 10, 2021 in forum: Subaru Sambar
  5. Rick Melloh
    Post

    Sambar TT2 ball joint sourcing

    Adam, Thanks for the tip. I continued my own search and came to much the same conclusion. I found a crossover reference to a Yokahama Motors part...
    Post by: Rick Melloh, Nov 7, 2021 in forum: Subaru Sambar
  6. Rick Melloh
    Thread

    Sambar TT2 ball joint sourcing

    Does anyone have a suggested domestically available lower front ball joint that fits a 2001 TT2, EN07Y? I am getting the shimmies. The left front...
    Thread by: Rick Melloh, Oct 30, 2021, 9 replies, in forum: Subaru Sambar
  7. Rick Melloh
    Post

    any buddy ever put full size tires on the sambar?

    I am using 175/70R14, Hancook I Pike mud and snows mounted on DRG DR31 S alloy rims, size 14x5.54-100/11435S with appropriate shim rings, 73-59.2...
    Post by: Rick Melloh, May 3, 2021 in forum: Subaru Sambar
  8. Rick Melloh
    Post

    thermostats

    I have a new thermostat for my 2001 TT2, but am not even sure what the angle of attack is to install it. I purchased an OEM thermostat. I remember...
    Post by: Rick Melloh, May 3, 2021 in forum: Subaru Sambar
  9. Rick Melloh
    Post

    4WD on Subaru Sambar truck does not disengage

    The solenoid switch could have internal corrosion, the actuator sticking on corrosion in the actuator cylinder, rust may have compromised the...
    Post by: Rick Melloh, May 3, 2021 in forum: Subaru Sambar
  10. Rick Melloh
    Post

    Sanbar Corroded Water Pipes

    I rebuilt my entire set of tubes with copper tubes and fittings. They all rotted out directly above the fuel tank. The diameter matches were good...
    Post by: Rick Melloh, May 3, 2021 in forum: Subaru Sambar
  11. Rick Melloh
    Post

    96 Sambar KS4 and I can't get the 4x4 to engage

    When my original TT2 solenoid failed, it worked intermittently at first, then not at all, leaving me stuck in 4wd. I tried giving the solenoid...
    Post by: Rick Melloh, May 3, 2021 in forum: Subaru Sambar
  12. Rick Melloh
    Post

    [SOLVED] Where can I find a rear right cv axle?

    Try AMTC Rebuild Center; 155 Bamboo Lane, Jackson, MO 63755. They can rebuild and reboot the CV joints on the axle(s) you have. I built a special...
    Post by: Rick Melloh, May 3, 2021 in forum: Subaru Sambar
  13. Rick Melloh
    Post

    2" suspension lift install/fab

    Banzairx7, I had to install rear shocks immediately after purchasing my 2001 TT2. The original shocks still functioned, but the sleeves had rusted...
    Post by: Rick Melloh, Feb 24, 2020 in forum: Subaru Sambar
  14. Rick Melloh
    Post

    2" suspension lift install/fab

    I have had my supercharged 2001 Sambar up to 80 mph on the freeway without modifications. There was a little more range left, but 80 mph seemed...
    Post by: Rick Melloh, Feb 24, 2020 in forum: Subaru Sambar