does not even need to be a wheel shop... A wheel shop might not even bother with it. They normally do high end alloy's. Take a big pipe wrench...
These are how you know Japan takes their smoking seriously
That can be bent out in a few mins to the point you would hardly, ever notice. This isn't a high end low profile alloy wheel. I've bent worse...
Not just one place, and not just a couple either.. Impex Japan, Amayama, Megazip, Partsouq, Ebay, various UK sellers and my local autoparts...
Yes they will fit... the 10mm in tread width is only that much wider. That is just a little more than 3/8".. It might sit 1/2" higher in total....
I had a '92 Suzuki Carry 5spd, which was my daily driver for a while. It drove best at 55-60 MPH but it could be rung out to 70 MPH and still be...
I have a set of 145R12 Y372's with only a couple thousand miles on them in my garage, however they have been long since discontinued. I think the...
Unfortunately that is not the case. The installed tires are trailer tires. DOT legal but not on a powered vehicle given the Special Trailer...
When I had my Jimny, I put a Die Hard Gold U1 which had a good warranty and iirc it was 500 CCA. Just rigged it up with pencil post adapters and...
Broker fills them out for you. That is part of what you pay them for
No, the wheelbase is about 50". These will barely fit on a 4 post lift/ allignment rack, if they do at all.
The clutch disc is about the only thing that swaps. Those plug wires may work if the connectors are right.. My '92 had the Hemi head, so the plug...
The RHB31 was designed and used in most of Suzuki's turbocharged 660cc applications
Even though I do not have my Jimny anymore, Vermont sent me a renewal for registration. So I would say, if you can get them to title it, they...
Look into something like a Toyota Liteace instead. That's a Ford Ranger sized truck that looks like a Kei truck. there are others. The Liteace...
Separate names with a comma.
