1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.
Jim Nelson
Last Activity:
Jul 21, 2018 at 6:07 PM
Joined:
Mar 30, 2010
Messages:
747
Likes Received:
25
Trophy Points:
28
Location:
Fallbrook Cal.
Occupation:
retired

Share This Page

Jim Nelson

Active Member, from Fallbrook Cal.

I'm kind of over loaded, give me a bit and I will try to find them.Could you pm me your email addy please. Dec 23, 2017

Jim Nelson was last seen:
Jul 21, 2018 at 6:07 PM
    1. Jim Nelson
      Jim Nelson
      I'm kind of over loaded, give me a bit and I will try to find them.Could you pm me your email addy please.
    2. Jim Nelson
      Jim Nelson
      I'm out of them,Magic Valley would be my best guess
    3. Bob32racing
      Bob32racing
      Ive been looking for an s80lp carb for sometime now, i know youve helped in the past. Where could i get a new or even used one?
    4. Corkmoto
      Corkmoto
      Hi Jim,

      I've been searching the forum and just bought an s65 1986 ? I believe hijet truck from Sdsu university with receipt only. No title.

      I want to get plates on it. Could you direct me to your registration guy who knows the way to get it plated? I don't want to go to dmv and get it denied. Thanks so much if you could help.
    5. firejonny89
      firejonny89
      Hey Jim I used 275 pound spring from summit or jegs one of the two u sed the heavier ones because of my front bumper is about 80 pounds plus winch or plow so I needed little more. If you don't have plans for a plow I would use 250 pound springs
    6. threepot
      threepot
    7. 2Tailfins
      2Tailfins
      Beautiful Truck- You ever want to sell it let me know!

      Cary
    8. TamiPaulus
      TamiPaulus
      Hi Jim,

      The truck looks really good. Congrats man!
    9. Jim Nelson
      Jim Nelson
      I am in Fallbrook,California
    10. woodhe1
      woodhe1
      Jim,

      I'm not sure where you are located at but I have a scissor/dump unit that I took off a Daihatsu. We used the unit to reverse engineer it for new units to be put on new Suzuki trucks.

      I am willing to part with this for $500.00. It comes with the cylinder but no power unit. The power unit that was on the truck was pretty much shot.

      I use 12 volt Dalton Hydraulic Power Units Dalton P/N DBH 350-230 to power the new units we build. Also get the PSN-012 15' Power Cord (up-down)

      let me know your thoughts.

      Thanks,

      Dan Woodliff
      www.woodysminitrucks.com
  • Loading...
  • Loading...
  • About

    Location:
    Fallbrook Cal.
    Occupation:
    retired
    retired equipment operator.! own a small farm in Southern Ca.

    Growing things,mini trucks.and compact tractors