I have a 94 Carry DD51T with a 2 inch lift. I’m looking to put the 250 or 275 front springs on it. Does anyone know the inside diameter of the stock springs? Also the stock height? Thank you
I would love to know this as well. My van has blue HD springs (probably 200-300lb) and I want to put some softer springs on it so it has a reasonable ride.
Yo member Farrell, Your post says "today", which is Friday, 11/05/2021. Hope I'm not in the past. Anyway, stock springs from my '95 Carry measure 2 3/4" inside, right at 10 1/4" free length. That's from wire end to wire end. I'd send them to you if you wanted. Cover postage of course.
Good to know. I have a van so I have 4 springs. I assume these are the fronts you took off of your truck? I think the front suspension of the van and the 2wd trucks are the same, more info I'll have to figure out. Thanks for the offer. I'll definitely get back to you when I'm ready, appreciate it.
And, knowing that you can shop online for springs to fit coil over shocks. Jegs and Summit both have a decent selection.
Except they don't. its almost all 2.5 ID. I think I found one that was 2.75 ID spring and only in one size and rate.
The trucks were made in Japan. They use metric. So the springs will be metric. Convert the 2.75 X 10-inches to 70 X 250-millimeters and take another look.
I'm hard pressed to find any metric springs in the 2.7 or 2.9 load range. When I do find them they are 5 and up (200+lbs/in) which is what I have.