1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

[SOLVED] Turn Signals not Working - 1991 Acty w/A/C

Discussion in 'Honda Acty' started by Sciteach, Sep 13, 2020.

Thread Status:
Not open for further replies.
  1. Sciteach

    Sciteach New Member

    I just picked up a 1991 Acty w/A/C. It's been running great.

    Turn signals worked on the way to Publix. Now they do not. No exterior nor interior lights.
    1. Fuse looks ok
    2. Headlights work

    Ideas? Thanks!
  2. Limestone

    Limestone Well-Known Member

    Take out your tester and get crackin! Start by checking power sources. Sometimes a fuse looks good and it's not! You can check a fuse with a test light, while the fuse is intact! Hence the small metal dots, or tabs on top of the fuse, at each top/side. See if you have power to the fuse and out! So if both turn signals are out, and the fuse is good, is there a relay/flasher in the circuit? Maybe someone with an acty can respond. Do you have emergency blinkers? I would think, that their on the same circuit!
    Last edited: Sep 13, 2020
  3. Sciteach

    Sciteach New Member

    It was the flasher. Picked up a new one, plugged it in, and now we're blinking! Thanks!
    MarsMini likes this.
  4. aomorisambar

    aomorisambar Member

    Had the same issue a few years back in my Subaru, tried everything, then found a relay way down stream buried behind the dash had to , pull off most of the plastic to get to it.
  5. Limestone

    Limestone Well-Known Member

    On my Daihatsu, it's right there, next to the steering column, on the fuse panel! Easy access!
  6. Casey M Pinch

    Casey M Pinch Member

    Sciteach, where is the relay? I need to change mine and can't find it. I looked at the diagram and no luck. Thanks for the help. For my 1994 Acty truck SDX
  7. shogun

    shogun Active Member

Thread Status:
Not open for further replies.

Share This Page