While the OE Subaru KS/KV boots were no where to be found, I found an Ebay seller that has universal boots that work with a little trimming, for $18 US shipped. There are two different ones available, one that is for a slanted shift lever [9025] and one strait [9026]. The one for the slanted, had closer measurements, but the other would probably work. They only come in black. https://www.ebay.com/itm/256742874181 He was a great seller and put in some time/communication, to get me measurements The foot print of the lower fold [accordion] was close to 4"x6" which is the opening of the '92 By taking the molded rubber lower skirt, trimming it and folding it up and over towards the upper fold, to make the outside 5" x 7", worked just fine. I just used a desk stapler to create the fold, that slides under the shifter trim panel, similar to how the OE boot is. Currently, it does move around a little, because of the slant, but the boot is not exposed to undercarriage air. A good two way tape [3M], will fix, once it outside temps warm up.
