Hello Everyone from South Carolina! Wanted to share pics of my 1992 Suzuki Carry project ( 4x4, axel/difflock AC , 25k miles ). Bed rack with jump seat mount and off road tire rack / snorkel getting built soon. Making patterns for bumper. Jigged up getting ready to weld. Light bar mount posts. Front skid plate mount brackets. Tacking up front skid plate. Ready for paint. Front bumper complete. Rear winch and custom mount ( Warn VRX 35 ) front winch is the same. Making the rock sliders. Welding them to the frame. Testing them out with high-lift jack. As far as the engine goes did a tune up plugs wires etc. Going to replace timing belt, seals ( leaking a bit of oil) Valve cover gasket and replace all fluids. I also have plans to upgrade the alternator and battery. I’ll post more pics as things progress. Lots of great info here thanks!
Looks great! Looks like you have on board air as well. I really like that front bumper too! Nice work and welcome!
Looking good, what thickness steel you used for the front bumper? After my dump bed mod is finished front steel winch bumper is next on the list.
You go to 14" on the T&Ws ?? What is the wheel B/S measurement ?? I can sell a wheel like that BUT it looked like it was to deep W/O running a spacer. Thanks
I used 11ga on the bumper and 7ga on the front skid plate and some angle iron to back up bottom edge of bumper and edge in front of winch. These are the wheels I used Pacer Pacer 84B 14x5.5 4x100/4x114.3 (4x4.5") +35mm Matte Black Wheel Rim Tires: Presa P102 185/65 R14 Winter No spacers. Using a 2” lift with 300lb springs had to use camber bolts both top and bottom but so far running well at any speed.
I am totally impressed with you fab skills. Did you fabricate the roof rack or did you find one that fits - if so I would like to know where I could get one.