1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Factory Electrical Manual 94-6

Discussion in 'Honda Acty References' started by Bert Stevens, Nov 2, 2020.

  1. Bert Stevens

    Bert Stevens Active Member

    Here is the lighting section. 10-2.jpg 10-3.jpg 10-4.jpg 10-5.jpg 10-6.jpg 10-7.jpg 10-8.jpg 10-9.jpg 10-10.jpg 10-11.jpg 10-12.jpg 10-13.jpg 10-14.jpg now I see how I did that. (insert) Just decided to do the whole section, so you all have it.
     
  2. orberto

    orberto New Member

    Ok Bert, you're a hero! So far I've learned that short coupler is a connector, and the little characters along the wires are the colors. The square E and square D symbols elude me still. They're always next to the wire colors. Any knowledge?

    (Yes, I know I'm on the turn signal page, not the parking lights. There's a guy on the FB group that posted a bit about his troubles with install using parking lights, and actually took the alarm off.)

    So, from what I see, the signals are the signals are the signals. Unless they're hazards. But that's just the first switch, and if hazards are off, then signals are usable. I'm thinking I can just splice my alarm flash to either red dots or green dots.
     

    Attached Files:

  3. Bert Stevens

    Bert Stevens Active Member

    if you tap into the turn signals you will need to use diodes to keep them from turning ON all, when you signal L or R. E and D are which harness wire are in.
     
    Last edited: May 11, 2024
  4. Truckin!

    Truckin! New Member

    Bert, would you know the color of the brake light Wire? I am also wondering where is might be along the frame rails, perhaps where the spare tire is mounted?

    I've added additional lights to the headache rack and would like to tap into the wiring. I know I can go another six feet and tap nearer the taillight housing, but....
     
  5. Josh86

    Josh86 New Member

    Hey Bert do you have the wiring diagram for the ignition coil?
     
  6. jlowe32

    jlowe32 New Member

    I'm not Bert, but I do have his wiring photo from another post. I'm fighting the ignition on mine right now.[​IMG]
     
  7. Josh86

    Josh86 New Member

    Awesome thanks so much hope you get your ignition problem figured out
     
  8. Eco24soilman

    Eco24soilman New Member

    Hi Bert,

    Can you help? I have a wiring issue with my rear lights. Do you have the wiring schematic for this please?
     
  9. Flexia

    Flexia New Member

    I have been trying to figure out my no spark also but this wire diagram doesn't seem to be correct for my 93 HA4 manual. I have a Black/Yellow and Blue coming out of the Coil right to the Distributor along with a Black ground screwed into the Distributor case. This is showing 4 wires to the Disturber and only one is Labeled
     
  10. Ethover

    Ethover New Member

    This is GOLD! Thank you for posting these.
     

Share This Page