1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Center Dash removal

Discussion in 'Mitsubishi Minicab' started by Michael MUMFORD, Feb 4, 2020.

  1. Michael MUMFORD

    Michael MUMFORD New Member

    I’m a newbie with these trucks and I want to remove the center dash to install some USB pprrts and need to remove the center dash but don’t want to break it. I could not find any screws so is there any special way to pop it out? Thanks Mike
     
    Michael MUMFORD, Feb 4, 2020
    #1
  2. Jigs-n-fixtures

    Jigs-n-fixtures Well-Known Member

    On my Hijet the dash center is held on with Two screws by the instruments, and then pretty standard clips, and pops off with the correct tool. I used some blue nylon panel tools.

    19Pcs Trim Removal Tool,Car Panel Door Audio Trim Removal Tool Kit, Auto Clip Pliers Fastener Remover Pry Tool Set with Storage Bag https://www.amazon.com/dp/B07HRNKY8P/ref=cm_sw_r_cp_tai_tbEoEb1MTT9B5
     
    Jigs-n-fixtures, Feb 4, 2020
    #2
    Limestone likes this.
  3. Michael MUMFORD

    Michael MUMFORD New Member

    Thanks I’ll give it a try.
     
    Michael MUMFORD, Feb 4, 2020
    #3

Share This Page