1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

1994 Acty Van oxygen sensor bracket location

Discussion in 'Honda Acty' started by JonP, Dec 5, 2019.

  1. JonP

    JonP Member

    Hey guys,

    I just got done doing a headgasket on the E07A. It's a big job, and took me a week to get done. Well, now I am trying to figure out where one last part went. It's a little L shaped bracked that goes from (what I think) is the oxygen sensor on top of the catalytic converter and then connects to an electrical connect at the distributor cap. On the bolt holding in the bracket, there is another ground that is supposed to tie into it that is from another electrical connector.

    I am drawing a blank. I have two bolts left, both go to the bracket that supports the exhaust, but there's no way to have the wire bracket get bolted there. So I must've lost one bolt and I can't even find where there is a bolt hole to put it!

    Thanks a bunch!

    Pictures: https://imgur.com/a/4x1wD3T
     
  2. shogun

    shogun Active Member

    Last edited: Dec 20, 2019

Share This Page