The vacuum advance on my dd51t only has one port for vacuum. That's what has me stumped on it. Unless I need to run my distributor through that...
The thermo can be cross referenced with a 94 2.2l s10. 180° only thing you need to do is pop a small hole in the lip to provide a burp hole
OK. I have a question in regards to the manifold switch that runs from the carb, to the intake, and to the egr valve. Do I have to use it even...
Ok. Soo...... I was looking for a fan switch that goes into the radiator and kept coming up with parts over 70 bucks! Well. Fleabay had the same...
Looking for conversion info for a pulley swap. Is there any pulleys that will swap directly over Is the crank pulley balanced? Alt is a no...
Right on. I checked and they were tight.. I'll be able to finish it up Sunday as I'm going to my family farm tomorrow my carry is a 1997 dd51t...
Thanks Fred. That's what I was thinking. I rechecked the timing belt to make sure it didn't jump a tooth. I did advance and retard the timing with...
I am posting a link to a short video I took of my carry. I'm thinking tight valves Vacuum gauge shows late timing. Reset dizzy to TDC. No...
3mm. 20ft covered what I did. That's all I saw though
I figured it out. But I was referring to the arm coming off the back of the choke diaphragm around gear mechanism for the choke
Another update.. I checked timing per Jim and spaners write up from several years back. I lined everything up on TDC on the compression stroke and...
Just throwing out some updates of my dd51t resurrection. So far Bottom end redone and ready for charger Valves adjusted Still figuring out...
Ok. I did a bit of drinking and thinking tonight.. I had a bit of an "Aha moment"! From the top of the idle up switch under the passenger seat, on...
If it is a dd51t, I would definitely check the idle solenoid that is in the carb to make sure it's working. Also.... verify that the vaccum lines...
Alright fellas. As you know I've been redoing a mess of a dd51t. All the diagrams that I have found show most of the vaccum line routes. I have 2...
Been doing a ton of work on my carry project. Got the 2 inch lift on, 300lb springs on, and 3 inch shackles in the rear. Also made 2 inch diff...
Hey fellas. I'm in dire need of a crankshaft for my f6a dd51t truck. Can anyone help me locate a good used one? Or even new if the price is right....
I've looked to see if I can Cross reference the part number. Haven't found anything yet. Another thought, could the valve guide being worn out...
Ok I've searched til I'm blue in the face, posted in the carry sub with zero replies. 1995 dd51t f6a motor I'm needing help finding a cross...
Separate names with a comma.