Looks like I'm pulling the head. Vac gauge is indictating the valves are intermittantly sticking. Makes sense since it's also burning lots of...
Shims?? No, I'm loosening the adjustment nut and turning the screw and retightening the nut, re-measuring the clearance at each step.
Turns out my carb, after I replaced the needle and diaphragm, is mostly fine. Still need to tweak it a bit, but mostly there. The real problem...
any good leads on a 2.5# inline regulator? Also... im thinking my valves somehow fell out of adjustment again, or it's eating the valve seats....
Mine is external pump, and not even the factory one. And the label fell off, so no telling what psi. I have a 2.5-4psi pump arriving tomorrow.
Jigs you're probably right there, so yesterday I cracked the fuel cap to stop that temporarily, let it sit a few hours, then tried to start it....
Link to pix seems broken!
Current problem: van wont start, hardly fires, smells rich, pumping throttle makes it worse, holding choke wide open only helps slightly but still...
Original calipers. No modifications were required, I brought in my originals to compare, took measurements, and sure enough they're identical.
I put swift rotors on the front of my 4wd Scrum van
Fair points. What are your suggested inexpensive tires for the above mentioned uses? I should also mention, I wont often be exceeding 10mph when...
My heater isnt blowing on any setting. All the fuses in the under dash fuse box test good, so I feel my next step is to test the leads going into...
I wouldnt think turf tires would work well on anything remotely resembling mud... We'll be driving on surfaces ranging from roads with mud an...
I've got a 94 Scrum Van that has the 4x114.3mm bolt pattern on it, and I'm trying to find some wheels big enough to fit some Carlisle Trac Chief...
Has anyone tried the Carlisle True Power ag lug style 23x8.5x12? The catalog says they need 7" wide rims! O_O
Is there a trick to getting the crank off the threaded post it sits on? I removed the castle nut, but the assembly wont drop down. Prying on it...
Verified those Chevy Sprint/GeoMetro/SuzukiForza front brake rotors fit perfectly.
If this cross reference thread is to be expanded to other Suzuki kei vehicles, I found rear wheel bearings for my DM51v van!! 6008 2RS EMQ C3 are...
Well, I'm assuming those vacuum valves are normally open, because even with power disconnected from the two valves I'm getting vacuum from both of...
^^ 99% sure that union is connected to the airbox hot idle compensator now, which lets extra air into the engine to lean it out when the fuel in...
Separate names with a comma.