War Wagon, finding wheels can be difficult for my 93 S93P but I'm not sure what your bolt pattern is on the 84. I also live in Washington and one...
Jerry, I did the carb swap with initial mixed results. I set my timing to 10BTDC @ 1000 rpm because that’s what it was when I got the truck. I...
Yea, I was thinking about dropping down to 23” from the 24”. Won’t make a huge difference but it will help. Plus the tires I have are not radials...
Thanks! I’ll take a look at that.
Wanted to post a reply to see if anyone has been able to find a kit/system that works? Again, I assume power assist is our only real option based...
Jigs, I saw that and was really considering. May be slightly above my fabrication level but he sure makes it look easy. Plus I’ve got a Jumbo so...
Thanks Jiggs. I figured 6.66 is as tall as I’m going to find. I’ll probably get 23” tires to replace the 24” I have and that will hopefully help a...
Jigs-n-fixtures, I was planning to post a new thread but this one is close enough to my topic question and you always seem to have the answers....
Can anyone share photos or describe how they’ve been able to make a manual choke cable work with the factory Hijet carb? I’ve tried 4-5 iterations...
Jigs, I ordered a regular tach to use mount for daily driving just to know where I’m actually shifting etc. I saw the induction type on Amazon...
We’ll I dove in and it really wasn’t too bad. Dash comes out really. Hardest part were a couple sticking electrical connectors but overall not too...
Calling out to anyone who can help a complete newbie to carbs dial mine in. She runs and drives finally after 2 years. Head and valve train is all...
Thanks Jigs. I just grabbed one off the Jungle website that will work. It says 1-10 cylinders so hopefully good. I need some carb setup advice,...
Jigs-n-fixtures, is there a thread about the Tuneup Tach? My next project and I haven't been able to find much. Thank you.
My issue was that I assumed I had the timing side correct. Then I kept adjusting the high idle screw too far down to maintain idle. Then when I...
Limestone, Thanks for the information in the post(s) above. I've finally gotten back on the Hijet after about 2 years off building a house and...
Jigs was correct, well I had another issue but defiantly think the canister was clogged. Pulled the gas cap and the issue eased. I say eased...
Jigs, Thank you, I will get my rig information in. I thought I had done that previously for the same reason. To check should I just hook up a...
I've had to take a break from the Hijet for a while, building a house took priority but I'm back at and looking for some expert knowledge....
Aaron, I've got a 93' S83P (very similar to yours) and am thinking about swapping my carb for an aftermarket manual choke as well. Did you end up...
Separate names with a comma.