I have a 1994 Daihatsu HiJet S110P. The outer left CV joint on that model could either be a 71 LAC or a 75 LAC. Where exactly is the number...
Thanks for the post. I changed the wheel bearings on the driver's side today trying to fix a squealing bearing. After reinstalling axle, I...
I was almost stuck in 4wd and heard a loud pop on left front wheel. After that my 4wd will not engage. I jacked all wheels off ground, pushed...
There is a thread on seals in general explaining that you can take it to a bearing shop and let them match it up with a replacement part. Mine is...
I took it to a shop and had the springs compressed and back together. For some reason the axel appears to be preventing the hub from tilting...
Strut Reinstallation Problem Alright guys you talked me into trying to install a set of 2.5"x10"x250# coil springs on my 1994 HiJet; however, I...
What size fan belt goes on an 1994 HiJet S110P with air conditioning?
I installed a cable from my battery to the rear receiver hitch where I can install my portable receiver mounted winch. I used heavy duty quick...
The transfer case is leaking fluid on my 1994 Daihatsu Hijet S110P. It appears to be coming from the seal where the drive shaft that leads to the...
I flushed my radiatory yesterday and noticed that my heater was not getting warm. I am afraid radiator stop leak caused my thermostat to stick...
I have a five speed with a/c. It does not work too good though.
When I let out on the clutch of my 1992 Daihatsu, it shimmies, shakes, and almost goes dead? The clutch is not slipping, but the cluch engages...
Greg, Did you also replace the front shocks/struts inside the new springs? Jim
Sam, I forgot about the big clip-on cover panel which goes around the instrument panel and around the radio/ac area. You can pry it off and...
Sam, In my 1994 model HiJet, there are three screws that attach the instrument panel to the dashboard. Remove these screws from the front of...
The interior map light in my 1994 Daihatsu HiJet has gone out. The light works on a battery, so there must be a short in the wiring. All of the...
I have been thinking about lowering my three inch lift. How do you plan on taking out the inch on front and back?
Greg, You have given me concise and good advice on two questions today. I do appreciate it. I will look at my winch wire tomorrow and...
I have a 3,000 lb. winch. I put a large (one inch wide) plug in 30 amp fuse in-line to the battery. The first time I put it under a heavy load,...
If your truck shimmies and shakes when you let out on the clutch, does it the clutch need replacing?
Separate names with a comma.