MichTrucks Do you offer a rear bumper with receiver for a 2001 Daihatsu?
Looking to purchase a rear trailer hitch for my Hijet - S210P. Any suggestions?
would like to have a set myself....these are "A" plates correct?
Never seen them
Can you post some pictures??...would like to see this rig.
I've tried 3 U.S. OBDII readers...no joy. I did find one from Autel, model JP701, that is advertised to work with non-U.S., Japanese spec...
Ok, here's a question for you corporate merger guru's...if something, say an OBDII reader, works with Japanese spec Toyota, is it backwards...
Here are the pictures of my steering linkage. [IMG] [IMG] [IMG]
I will post a picture of my setup this evening
My linkage is setup from the factory similar to the picture I drew, minus the offset. The steering rod on the steering box pivots inside the boot,...
Do you have power steering? I don't have enough room between my steering linkage to have a pitman arm that length. Mine would require the arm...
Well crafted! That looks much better than standard square/rectangular tubing. Is that channel on the top and bottom or flat bar with rolled edges?
Ok thanks for the help. My steering linkage is nothing more than 3/16" thick 1.5" wide flat bar bent into a U shaped bracket. I figured I could...
Check this thread, might point you in the right direction. http://www.minitrucktalk.com/showthread.php?t=4015
Forgot to include this, yes axle crossmember = differential support.
Thanks for the feedback. During testing, when I lowered the the axle cross member to the full 2.5", the drive shaft impacted the engine cross...
Like the other guys said, you need to shim the front end, or cut your lift down to less than 3". With a 2.75" lift on my Hijet, the axle...
That would be an easy fix, however I think I would be pissin' in the wind. I've spent all day testing various ideas. As it stands now, when the...
I'm going to inspect the chasis today and see what is involved with spacing the suspension cradle. Not to slam anyone, but FYI, my lift was...
I'm in need of some positive suggestions here. The truck in question is a 2001 Daihatsu S210P. I finally installed my 2.75" strut spacers this...
Separate names with a comma.