Looks like the replacement used front left (short) axle swap cured the popping. Also measured the front lift and it is ~2 inches (2.5" on the...
Well - - after a long 7 months and a 12 week+ delay (for a rear axle seal) from a Mini Truck parts source in the US (name withheld unless you PM...
Well - it's been a very UNprodutive time for the HiJet. I AM STILL WAITING on a rear axle seal from Mike at SuperMiniTrucks. I've been waiting for...
Battery box cover stills available? I'd be happy with some aftermarket/ DIY solution as well. Thanks
I picked up a few but have not had a chance to install them. MAYBE this weekend - if I'm lucky.
I would imagine there is a worn or dried O-Ring seal causing oil to leak around the distro shaft. Google 'oil in the distributor' and look at the...
I got my replacement carb from Don at Yokohama as well. I have a couple of U Joints on the way.,... HOPING that's the issue. Time will tell.
Sounds like a crack in the distributor cap to me..... with my very limited HiJet knowledge. But that theory would apply to every points-fired...
Well - the beast is running and idling. Some good info on this forum (splauchs and others) suggested long ago that I test with a different tank...
Resurrecting this old thread as I am also in search of detailed info on vacuum lines and what they do/where they go. I need this info to...
I'll look into the boat bulb thing. I'm not familiar with it. Thanks
I STILL haven't had the opportunity to try the gravity feed of fuel to the carb..... but can't help but wonder - - out of all of these vacuum...
I haven't gravity fed the gas from the tank directly to the carb.... but I did eliminate the stock steel fuel lines and rubber lines. I pulled the...
I'll try to set up a gravity feed feed and catch bucket for the return soon. I'm no carb guy either - easy to see that, huh?!? Keep the info...
Well.... just an update.... I was able to start the HiJet yesterday afternoon. I just pressed the gas pedal to the floor and cranked away. It...
Maybe a dumb question, but what "sets the choke"? Pushing the pedal down once? Just the temperature outside? Temperature of the engine?
Here are some picts of my original carburetor. Since my problems persist, I doubt there is anything wrong with the original one. I'll probably...
Before I get flamed for over posting to my own thread... Let me repeat that I'm doing this to document my learning process and my own HiJet...
Considering I have no clue where the gas cap vent might be, I am soaking the stock cap in some detergent and water over night. I might resort to...
After charging the battery more and putting the charger back on Start Boost mode..... It finally turned over 3 or 4 times. No start but at least...
Separate names with a comma.