Put a open box, or two, of moth-balls in your truck and that will help keep the mice out...I remove them when I drive mine
I used wrist pins out of a engine, 1066 IH To make the spacers to lift mine and then used some more of them to drop the crossmember It...
When I lifted mine I used wrist pins from a 1066 IH tractor As spacers, worked great.
Search the older post this has been covered and you will learn alot of other stuff
Start chasing the spark down, coil, condenser, cap, bug, switch, etc. sorry I can't be more help than that
Would make a good BOV
Damn the bad luck
I had my 3 speed replaced with a 4 speed, I don't regret it one bit.
Don, sorry if I was steering auburn wrong, but I was assuming that his truck was one of the trucks that was gov. to 25 mph. My apologies.
PM Dan. He can explain any questions you have, after you have done a search, Dan is the man on the Mits.
Anything is possible with a cutting torch and a welder.
You have to change the distributor, and not all 3 speeds can be changed into a 4 speed, you might have to get another tranny. Try sending Dan a PM...
Tax deduction, dependent.
Did this on a toyota truck one time, worked great.
Deductions +1
Start by checking the wiring to the motor on the pump, fuses, does it have fluid in it? Are the seals blown in the pump? If so repair kits can be...
I defended myself by pointing out that it was a B cup, but that led to still another fight. Damn woman is a historian, keeps bringing up the past.
I bought a dodge dakota once and found a bra stuck in the seat in a place that wasn't sewn, a couple of years latter my wife found it, I should...
On my '93 two guys can pick up the bed if it is not running, and then put the prop under it. Maybe the fuel relay, located behind the glove box is...
I have had my truck to G&R a couple of times, they stayed within their estimate and did a good job, had a little problem and they corrected it...
Separate names with a comma.