I have given all the information needed for everybody to make their own decisions on what they need and how to get it. Yes, it is a Suzuki but...
It was over in the Pirate 4x4 forum in the Side-by-Side room. It's pretty bad...I like the HID lights and bar on the front...and everything else...
[IMG] Is this what you saw??
Yep...and cover fits back on. Yours looks to be the same canister that I have on my '91 (check your part number) so it might work.
What part number is that?? I got an E-0870 K&N filter for my '91 and with a little trimming on the outside edge of the filter gasket to clear...
87 runs the best in my Carry. I put 93 octane in and it didn't want to idle but would run good while in motion. After I used up that tank, I put...
A big +1...
Or if you still have your lift in, you could just trim the spring...
Couldn't you just jack the truck up under the diff and see how much the suspension drops with the weight off of it?? I mean, it it's overextended...
The 'klunks' and 'bangs' are just results of the lifting that you will have to live with. If you were driving down a paved road at highway speed...
I am almost sure your not bottoming out, it would take a fair amount of weight and force to do that with those springs. I have yet to bottom out...
Is that from a fire department here in Northern IL that has that are did you put that together for s***s and giggles?? It looks pretty cool, I...
That's good to know since I can drive there in less than 45 minutes...
I put the 10" 250 lbs. rated springs in my '91 Carry purchased from the e-Bay seller chassis_warehouse. I'm 6' 200 lbs. and it doesn't hardly sag...
Here's a picture of the 8068 I installed on my Carry. Also, I've taken out the radio and have installed three power outlets and a voltmeter...
I got the tach mounted but only after finding out the tach I got off of eBay was a dud so to O'Reilly's to get a new one. I mounted it today but...
Here is what I got from the Carry area. This is a quote from a question sent to Equus about three cylinder compatibility: 'Our model 6068,...
I think regardless of what you have, your not going to get in licensed in IL. The state does allow them on roads that are less than 25 mph and...
It the shaft is 30 spline then there is a good possibility it will.
I actually set my foot on the edge closet to the door when I drive. My ankle would hurt with the actual gas pedal so out came the grinder and a...
Separate names with a comma.