1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

94 Carry Front Spring Size

Discussion in 'Suzuki Carry' started by Paul Cianciolo, Oct 14, 2019.

  1. Paul Cianciolo

    Paul Cianciolo New Member

    I have a 94 Carry DD51T with a 2 inch lift. I’m looking to put the 250 or 275 front springs on it.

    Does anyone know the inside diameter of the stock springs? Also the stock height?

    Thank you
     
  2. Paul Cianciolo

    Paul Cianciolo New Member

    Yello! Anyone still left on this forum?!
     
  3. Jigs-n-fixtures

    Jigs-n-fixtures Well-Known Member

    Just a guess, they will be 2.5-inch ID, and 12-inch free length.

    But that is just a guess.
     
    t_g_farrell likes this.
  4. t_g_farrell

    t_g_farrell Active Member

    I would love to know this as well. My van has blue HD springs (probably 200-300lb) and I want to put some softer springs on it so it has a reasonable ride.
     
  5. Uncle Eddie

    Uncle Eddie New Member

    Yo member Farrell,
    Your post says "today", which is Friday, 11/05/2021. Hope I'm not in the past. Anyway, stock springs from my '95 Carry measure 2 3/4" inside, right at 10 1/4" free length. That's from wire end to wire end. I'd send them to you if you wanted. Cover postage of course.
     
    t_g_farrell likes this.
  6. t_g_farrell

    t_g_farrell Active Member

    Good to know. I have a van so I have 4 springs. I assume these are the fronts you took off of your truck? I think the front suspension of the van and the 2wd trucks are the same, more info I'll have to figure out. Thanks for the offer. I'll definitely get back to you when I'm ready, appreciate it.
     
  7. kip thompson

    kip thompson Member

    My 95 carry springs 10 inches long 2.75 inch ID
     
    t_g_farrell likes this.
  8. t_g_farrell

    t_g_farrell Active Member

    Good to know and an inch and a half longer.
     
  9. Jigs-n-fixtures

    Jigs-n-fixtures Well-Known Member

    And, knowing that you can shop online for springs to fit coil over shocks. Jegs and Summit both have a decent selection.
     
  10. t_g_farrell

    t_g_farrell Active Member

    Except they don't. its almost all 2.5 ID. I think I found one that was 2.75 ID spring and only in one size and rate.
     
  11. kip thompson

    kip thompson Member

    You are correct
     
  12. Jigs-n-fixtures

    Jigs-n-fixtures Well-Known Member

    The trucks were made in Japan. They use metric. So the springs will be metric.

    Convert the 2.75 X 10-inches to 70 X 250-millimeters and take another look.
     
  13. t_g_farrell

    t_g_farrell Active Member

    I'm hard pressed to find any metric springs in the 2.7 or 2.9 load range. When I do find them they are 5 and up (200+lbs/in) which is what I have.
     
  14. t_g_farrell

    t_g_farrell Active Member

    @Uncle Eddie , I'll PM you, thanks.
     
    Last edited: Jan 3, 2022

Share This Page