This is the head with the studs just so you can see there height not much taller then stock bolts. only down side i see is now i would have to...
Cylinder head installed with the ARP setup
Just a few pics of the short block. F5B by Zakath posted Apr 27, 2020 at 2:01 PM Rebuild 2020 by Zakath posted Apr 27, 2020 at 1:58 PM
Short block with ARP studs
that's the short block
I had to do mine abit different mine had no title so I ended up getting some paperwork done at the courthouse just saying that I was the rightful...
So I made it to the shop and looked diligently at my distributor and no stickers or numbers on it that can be read. In other news I found some ARP...
Well if it was a sticker and not a plate. It is gone when I get back to the shop I'll try to snap a few pics of it
On my distributor I see no numbers or manufacturer. Unless it is stamped under the rotation assembly. I did order new rotation assembly bearings...
Hello all, So here it is i blew the head gasket again. my only thought is the bolts stretched 3 were not at 68NM. So i decided to take the engine...
does it have vacuum hubs? and how i test vacuum valves is use a long vac hose connected t engine manifold vac start engine and test. if a solenoid...
on my F5B it was Int .06 Ext .08 cold but you may want to call G&R imports they are very helpful. Web is https://www.grimports.com/
Thank you i am so stoked that it runs as good as it does. had to fix a few water leaks but now it does not pee on my shop floor.
It lives again got this little baby up and running. most of the equipment works. i don't know how long this truck has been sitting but its working...
Separate names with a comma.
