I just cracked the Suzuki rear drum brake parts puzzle by using various parts from RockAuto to do it cheaply. Wrote it all up here...
The original rear brake line that runs across the axle will need to be cut in half and a tee put in place. Then a hard line from the single rear...
So the shoes and wheel cylinders mentioned in the previous post didn't work out. The wheel cylinders were way too large and moving the parking...
Its too bad these don't end up in junk yards much. Pull-a-part was always a go to for my rx-7 (until recently anyway) :):)
So ordered wheel cylinders and shoes from rockauto for $52.65 to do the rear brakes and replace the contaminated shoes. The plan is to drill some...
My right rear brake wheel cylinder is leaking fluid now. I'm searching for crossover parts right now and will update my brake thread with the...
So my right rear wheel cylinder has basically lost its seal. So will be looking to see what wheel cylinder would work based on rockauto Suzuki...
If you get shocked touching the cap then the cap is either cracked or the ignition circuit ground is not working (sparkplugs) well. I think your...
Are you sure the cable is fully seated into the cap? Maybe its working its way loose over time. Your tape may not be fixing it, it may be that in...
Nice work! You don't need that EGR stuff and the catalytic convert can have the honeycomb removed if you do an exhaust. BTW, the exhaust caused...
Interesting, that electronic enrichment. Hows that work anyway? Also maybe some crude wiring diagrams to understand what your are doing with the...
Correct.
You probably need to use shorter springs if they are coils. Otherwise if they are leaf springs, you can mount the axle over instead of under the...
My engine mounts are I think very compliant. Lots of clanking about whenever the rear end hits bumps. Annoying more than anything. Looked into...
@ralph peaston I looked into it and I got new wires on 500yenshop.com last time and they were genuine NGK. Very well made....
Separate names with a comma.
