MichTrucks Do you offer a rear bumper with receiver for a 2001 Daihatsu?
Looking to purchase a rear trailer hitch for my Hijet - S210P. Any suggestions?
would like to have a set myself....these are "A" plates correct?
Never seen them
Can you post some pictures??...would like to see this rig.
I've tried 3 U.S. OBDII readers...no joy. I did find one from Autel, model JP701, that is advertised to work with non-U.S., Japanese spec...
Ok, here's a question for you corporate merger guru's...if something, say an OBDII reader, works with Japanese spec Toyota, is it backwards...
Here are the pictures of my steering linkage. [IMG] [IMG] [IMG]
I will post a picture of my setup this evening
My linkage is setup from the factory similar to the picture I drew, minus the offset. The steering rod on the steering box pivots inside the boot,...
Do you have power steering? I don't have enough room between my steering linkage to have a pitman arm that length. Mine would require the arm...
Well crafted! That looks much better than standard square/rectangular tubing. Is that channel on the top and bottom or flat bar with rolled edges?
Ok thanks for the help. My steering linkage is nothing more than 3/16" thick 1.5" wide flat bar bent into a U shaped bracket. I figured I could...
Check this thread, might point you in the right direction. http://www.minitrucktalk.com/showthread.php?t=4015
Separate names with a comma.
