The large diameter pipe I just cut out the bad spot, replaced the spot with some armored radiator hose. There are custom speed shops in the...
Since I am in Japan the thin-wall steel pipes are metric, makes it easy to replace. You probably could find some tubing at HomeDepot or one of...
My advice is to change the coolant if you are replacing the water pump. So yes, drain it. Flush out the system good, you dont want to take the...
According to the manual you leave the tensioner bolt just lose enough so it floats then rotate the crank 4 full turns (that’s 2 revolutions of the...
Fupabox gave good info on the impact wrench. From what I have read on the forum, his answers won’t steer you wrong. I have found that...
The correct plug for a 91 Sanbar Supercharger is NGK BKR6E-11 If you want the Irridium plug its BKR6EIX-11 That’s according to the Japanese...
DITTO on the removing the coil. :pop: When I did mine, I only bumped the starter and immediatly switched off the ignition; however, it was long...
I agree 110% with the anti-rust additive being gone. Do you think there is anything to electrolysis erosion here?
To clarify about the water in the post above : I generally use 50/50 antifreeze/water in my vehicles. One gallon of water is considerably...
Fupabox Thanks for the feedback, your comments are appreciated. Great New Years Resolution, hopefully more will participate. That’s how we made...
Corroded water pipes. ’91 Sanbar EN07 See attached JPEG I have not come across corroded water pipes in a car or truck as seen in the...
Tripper If you weren’t the moderator that approved my Water Pump Pipe/Thermostat Hose Replacement; please look at it and give some feed back, I’m...
Replacing water pump/thermostat hose located below carb (see attached JPEG 1, JPEG 3 part #H625011) This is a how and how not to change the...
Separate names with a comma.