Any resolution yet? Mine started doing a similar thing last week. I wonder about floats in the carb being stuck. Seems the accelerator pump will...
In a CV setup, does the slip have to go in the shaft or would it be ok to leave the slip at the output?
I appreciate the help, I'm pretty green here lol. I put some straight 4" blocks in and raised the t-case back to the stock location. That gave me...
I appreciate your input, and I understand it's not ideal, but I'm pretty sure there is more than 3 degrees driveshaft angle from stock. I'm not...
I did that. That made 2wd better. However, that makes the front shaft vibrate to the point of chattering my teeth. If I go over 30kph, I'm quite...
If there is room, maybe you could run a chain drive jack shaft between the engine and your driveshaft to get a better ratio. Probably a lot of fab...
If it's a u42, and if my memory is correct, there's a nut behind the number plate, one behind each signal lamp and some fasteners on the edge...
How is everyone handling bigger lifts in regards to the rear shaft? Little back story; 1994 Mits U42t. So I built myself a lift kit, dropped all...
I'm trying to chase down a problem in my 95 u42t. Blowing black smoke. Loads up on fuel and you have to play with the throttle to clear it out....
Sorry, just read your post more thoroughly. You dropped everything 3 inches and can fit 27s. Any rubbing on suspension compression?
Hey, what did you have to do regarding toe in? Im currently installing 1.75" spacers along with heavy springs amd am running out of tie rod before...
1995 u42t 3g83 Anyone know where ported vs manifold vacuum takes place on this rig? After the throttle plate looking from the air filter side i...
Separate names with a comma.