Try some Honda rims. Worked for me. Cut the hubs, not the wheels though.
Had the original battery die in my 97 hijet. Bought a PC 625 Odyssey. The clamp on the pos was eroded away so I clipped the end off but left the...
With the 3 coil setup the twin cam has, there is no plug wire but the pos and neg wires are accessable on the coil. The coils set directly on top...
That almost appears to be what increases the idle when the a/c kicks on.
One must use caution here. Some earlier US manual trans use 75-90, 85-140 or so. Later manuals use lighter trans fluid.
My cousin in VA has a 3 cyl bike. My experience with motorcycles is limited but is there an angle there? Also, the spark pickup on my 97 is...
I was thinking, if there are individual spark coils, why not use a 1 cyl tach?
No bull. It seems to me I should have taken some pictures of this. I have to say that getting the valve cover off is a fairly easy job, and has...
It does make sense. I did find that if the lobe was away from the follower, it could be pried to open the valve and the quarter sized piece,...
Yes, that was the case, as a result of dirt getting past the wing nut of the air filter cover. The wings were too long and hitting the cap but...
I see now. The cams fit in like a crank with half of the bearing being the head and the other half being the bearing cap. There are no bearings...
The twin cam version I have is not adjustable with tools. There may be a way to get thinner cam followers but I don't know. I had dirt cause the...
I just took one pic of the two cam gears where the timing marks meet. There are multiple marks on each cam gear on the back side towards the...
I had to pull the cam to remove the cam followers to expose the top of the valve stem. The valves wouldn't seat cold and it wouldn't start. I...
Some motorcycles run 3 cyl. Anyone have knowledge that might be usefull?
Separate names with a comma.
