I picked my welder up new for under 100 bucks.. its crappy but it does the job. The more I weld the better I get with a grinder.
I keep having issues with water washing the grease out of my wheel bearings... its very annoying and getting very expensive...
No.. you can not sand it and bondo it... if there are holes you need to cut and weld. Bondo will just allow it rust faster. You can try hit it...
So.. maybe its not bad.. but the ladies like it :P [ATTACH] [ATTACH] and yes.. I know.. my battery tray is fubar...
It'll be an ignition problem most likely. If you are SC you should have an EI dizzy so it won;t be points (unless you have points for some odd...
So I have given and caved.. had to get it in from Japan... The B5 bearing the closest available here and it is 1mm to small.. :(
did you replace the water pump at the same time? if not be sure it is spinning... My pump seized up and this is what killed my timing belt.
Does anybody have the part number for front wheel bearings? I'd like to try find a local source instead of paying 100 bucks a bearing...
Front brake pads - 93 Subaru Justy (From thread on this board. Can somebody please confirm part #?)
[img] Where: Spanish Banks (UBC) When: April 28th Time: 10-3 Cost: TBA AJC is now a two day event! April 27th, Scott Road Skytrain...
came on after I hit a puddle, hope its just a sensor. Thanks!
I hit a puddle the other day.. not even a big one and the truck started to sputter and died out. Points issues... thing is once it decided to stop...
Separate names with a comma.
