Hi from Calgary. Wondered if it was possible to pick your brain for a few minute regarding your import spreasheet? Interested in importing a truck from Japan using Scott. One of his people Yoshi is corresponding with me, but fees are not clear. MIke Rae 403 874 8232
Hey, t_g. I'm trying out your brake conversion on my DD51T as soon as the parts get here, but I was curious if you ever found new drum shoes
My brake shoes and hardware are almost new when I got them so haven't seen a need to replace yet. Hardest part is getting the wheel cylinders, probably have to split the rear line to use anything common.
I have a 2020 Daihatsu hijet truck can not get in low range remove cable and can not get the lever on top of the transmission to move. Ideas
Beachbug! I am about to start some 1996 Atrai projects. How did those springs and shocks work for you? Have any final photos?
Trying to figure out the orange light on my dashboard, it’s on the left of main display, I have right hand drive, it doesn’t always come on?
https://www.amazon.com/INFINAUTO-Ignition-Control-No-MD607814-1986-1989/dp/B0CWGYKR7K/ref=sr_1_14?sr=8-14
I have a 2003 mini white van , it's a Cushman with a 4G82 Mitsubishi engine . Will the pinto ignition module work on this model ?
I got the smallest car hauler that U-Haul offered. The trailer is nothing but two ramps on wheels. The center is open. I made sure my mini truck would fit without falling through the center. It was a very close fit. Kevin in NC
Thanks. That is what I will get if I buy a Sambar or maybe I will ride my scooter over there and put it in the back of the truck.
Limestone; i am hooked on a mini with scissor/tip.I have not found one YET .so i'm going to build a tandem axle trailer with a removable (from the running gear ) scissor/tip dump ( I can pull with one of my tractors) .i would appreciate it if you could a few measurements the length and width of the bottom frame and the length of X frame and where they pivot,( is it in the middle or offset ) Thanks BILL
Hello All, im a newbie to the KEi truck world. BEen a VW/Porsche guy since i could hold an angle grinder.
Hey hey people I’m new here and just ordered a 1999 Daihatsu hijet from ozark mini trucks in Arkansas…anyone have any dealings with them?
