1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

New Profile Posts

  1. mike rae
    mike rae mtslesse
    Hi from Calgary.
    Wondered if it was possible to pick your brain for a few minute regarding your import spreasheet?
    Interested in importing a truck from Japan using Scott. One of his people Yoshi is corresponding with me, but fees are not clear.
    MIke Rae 403 874 8232
  2. Dumpai
    Dumpai
    2 weeks ago I got my sambar dump and I have been a very busy bee retrofitting and updating!
  3. Jim McIntosh
    Jim McIntosh
    94 k-van Suzuki 2wd 2" lift. Need new longer rear shocks, bounce, bounce bounce
  4. Jim McIntosh
    Jim McIntosh
    kvan 94 2" lift need new shocks. Any advise? More the 19" travel needed
  5. Suhgurim
    Suhgurim
    89 Suzuki Carry Turbo
  6. xP3ZINATORx
    xP3ZINATORx t_g_farrell
    Hey, t_g. I'm trying out your brake conversion on my DD51T as soon as the parts get here, but I was curious if you ever found new drum shoes
    1. t_g_farrell
      t_g_farrell
      My brake shoes and hardware are almost new when I got them so haven't seen a need to replace yet. Hardest part is getting the wheel cylinders, probably have to split the rear line to use anything common.
      Oct 14, 2024
  7. Robert Lord
    Robert Lord
    1991 Suzuki Carry DD51B (dump)
  8. FunDirectorinGA
    FunDirectorinGA
    Building my Minicab
  9. FunDirectorinGA
    FunDirectorinGA
    Novice Expert - Building my Truck
  10. 7268
    7268
    I have a 2020 Daihatsu hijet truck can not get in low range remove cable and can not get the lever on top of the transmission to move. Ideas
  11. Buff60Indian
    Buff60Indian beachbug21
    Beachbug! I am about to start some 1996 Atrai projects. How did those springs and shocks work for you? Have any final photos?
  12. Nils B
    Nils B
    Trying to figure out the orange light on my dashboard, it’s on the left of main display, I have right hand drive, it doesn’t always come on?
  13. Scott gibson
    Scott gibson
    No spark @ coil new coil starter grounds cap rotor etc
    1. Willybebb
      Willybebb
      Maybe your ignition control module. its under the distributor cap. you can get off of amazon.
      Sep 20, 2024
    2. Willybebb
    3. Scott gibson
      Scott gibson
      There is an igniter under the cap i guess that is my next step
      Sep 24, 2024
  14. Lstrbl
    Lstrbl
    I have a 2003 mini white van , it's a Cushman with a 4G82 Mitsubishi engine . Will the pinto ignition module work on this model ?
  15. BB Sambi
    BB Sambi time_to_dai
    What a small world!
  16. TeeLs
    TeeLs
    Looking for 95-99 Sambar, w/AC, 4WD
  17. Glenn Arseneau
    Glenn Arseneau
    Let's work together
  18. MichTrucks
    MichTrucks
    Specializing in the Hijet S500 and S721 family of trucks.
  19. MichTrucks
    MichTrucks
    Now specilizing on the Daihatsu
  20. Ron Dio
    Ron Dio banzairx7
    I have a 97 Sambar and interested in purchasing a 2” body lift kit from you
  21. Kevin in NC
    Kevin in NC Barnone
    I got the smallest car hauler that U-Haul offered. The trailer is nothing but two ramps on wheels. The center is open. I made sure my mini truck would fit without falling through the center. It was a very close fit.
    Kevin in NC
    1. Barnone likes this.
    2. Barnone
      Barnone
      Thanks. That is what I will get if I buy a Sambar or maybe I will ride my scooter over there and put it in the back of the truck.
      Jul 27, 2024
  22. LAZ E ACRES
    LAZ E ACRES Limestone
    Limestone; i am hooked on a mini with scissor/tip.I have not found one YET .so i'm going to build a tandem axle trailer with a removable (from the running gear ) scissor/tip dump ( I can pull with one of my tractors) .i would appreciate it if you could a few measurements the length and width of the bottom frame and the length of X frame and where they pivot,( is it in the middle or offset ) Thanks BILL
  23. Nick Kosovich
    Nick Kosovich
    Hello All, im a newbie to the KEi truck world. BEen a VW/Porsche guy since i could hold an angle grinder.
  24. joey pass 27
    joey pass 27
    Hey hey people I’m new here and just ordered a 1999 Daihatsu hijet from ozark mini trucks in Arkansas…anyone have any dealings with them?
  25. Gopi
    Gopi
    Hello Everyone
  26. joey pass 27
    joey pass 27
    Hey there people has anyone ever dealt with Matt from ozark mini trucks in Arkansas?
  27. Doc
    Doc
    New member: 1991 Hijet S83P Climber. Here to learn from the experts about this cool little truck.
  28. T-bill
    T-bill
    Hijet hijinks!
  29. Dumpai
    Dumpai
    Kei truck Noob
  30. S.Hiro